United Process Versapro Uživatelská příručka stáhnout pdf (Strana 10)

10 Important Product Information

GFK-1671P

Special Operational Notes

Opening VersaPro 1.x created folders

When opening VersaPro 1.x folders, the following dialog will be presented asking if you want to re-check the folder. The

purpose of the re-check is to flag any syntax errors that were not being caught by 1.x versions and to update the folder to

support the new functionality provided in VersaPro 2.0x. It is recommended that you select Yes, perform a check all on the

folder and correct any syntax errors. After going through this process, the message will not be presented the next time the

folder is opened. To avoid inequality issues with the PLC, it is recommended that you open hardware configuration, save it in

the new format and store your logic to the PLC. These operations are required because new functionality has been added to the

VersaPro 2.0x folders. However, the program and configuration are functionally equivalent to what was previously stored to

the PLC using VersaPro 1.x.

If you open a folder created in a previous version of VersaPro, select Yes to the message below and re-check it, you will not be

able to reopen the folder in the VersaPro build it was created in.

Selecting No will not force you to re-check the folder or correct any syntax errors. In addition, you will be able to gain equality

with the PLC and monitor existing logic. However, the dialog shown below will appear each time the folder is opened and the

logic portion of the folder will be in a read only state and will allow only limited operations.

Logicmaster 90-70 Folder Import Procedures

If you have a Logicmaster 90-70 folder created before Release 6 of Logicmaster, you should use the following procedure to

import your Logicmaster folders into VersaPro:

1. Open Logicmaster 90-70 Release 6 or greater.

2. Press F1 to enter programming mode and select any folder.

3. Press F8 (Program Folder Functions) and then F1 (Select/Create a Program Folder).

4. Select the folder to be imported into VersaPro followed by Ctrl-T. You will see a message “Converting old logic files to

new format, please wait ...” followed by “File conversion complete; press any key to continue”.

5. In VersaPro, create a new folder based on the Logicmaster folder.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Žádné komentáře

United Process Versapro Uživatelská příručka Strana 10